Why the Private Label Carton Quote Looks Cheap Until It Lands
In September, a US buyer of sizing Guide ordered 200 sizing Guide and asked for the same lost-wax cast as a competitor's sample. What arrived matched the photo and missed the drawing, and 13 pieces had to be reworked at the buyer's expense, quoted at USD 45-252 per piece in private-label carton with hangtag.
In the Private Label Carton file the failure was already written down. Prong geometry sat in the buyer's own incoming report from the previous season and nobody carried it forward, so the same line failed twice, and at USD 45-252 for 200 pieces that is the number the buyer signs.
The second run shipped private-label carton with hangtag with the spec stapled to the packing list. Zero rejects on arrival, and the buyer's own bench stopped re-inspecting, and the Private Label Carton quote for it sits at USD 45-252.
The Measurements Behind a USD 45-252 Quote
Specification is the only part of a sizing Guide quote that survives the season. These four measurements are what we write into the private-label carton with hangtag paperwork, and the Private Label Carton quote for it sits at USD 45-252.
| Spec point | Common trade output | HOLYCOME standard | Cost if missed |
|---|---|---|---|
| Stone colour consistency | Graded by eye under D65 | Colour matched to a retained master stone, per tray | Repeat colour complaint in the same SKU |
| Sizing drift across the run | Not measured | Go/no-go gauge on every size, drift held under 0.15 mm | Resize queue and reship cost |
| Clasp spring life | Sampled by hand | Cycled 500 times on a jig per lot | Detach claim and brand damage |
| Prong tension and seat depth | Checked by feel at the bench | Pull-tested per piece, seat depth written on the sheet | Stone loss and total replacement |
Every line above is measurable with a gauge and a scale. At USD 45-252 per piece, a supplier who cannot state them is selling a photo.
Private Label Packaging for sizing Guide
Private label changes four things and none of them is the piece: the stamp, the hangtag, the box and the barcode. Get those four aligned before the first bulk run or the carton arrives with your name spelled two ways, the figure being USD 45-252 for a 200-piece run.
The stamp goes inside the shank or on the clasp tag, and it has to be small enough not to break the surface on a thin sizing Guide. Below 0.8 mm of shank width we recommend the hangtag only, and 200 pieces leaves Wuzhou in private-label carton with hangtag at USD 45-252.
Cartons are quoted at 200 pieces with the label printed, not stickered, because a sticker on a matte box reads as a repack. Lead time adds three days for the print run, which is why private label starts later than stock, which is USD 45-252 on the Private Label Carton schedule.
What a USD 45-252 Quote Hides
The 200-piece Private Label Carton price splits as below. The line that decides season two is the plating and QC share, not the metal, on a 200-piece Private Label Carton order at USD 45-252.
| Cost line | Share | What moves it |
|---|---|---|
| Base metal or alloy for sizing Guide | 34% | Alloy choice and casting yield |
| Stone or melee for sizing Guide | 25% | Sieve range and lot batching |
| Setting and finishing labor for sizing Guide | 22% | Jig design and bench minutes |
| Plating, polish and QC for sizing Guide | 15% | Per-tray versus per-piece checks |
| Packaging for sizing Guide | 4% | private-label carton with hangtag |
Five lines, one price. If the supplier will not break them out, the number being compared is not a sizing Guide price, certified GRA report and packed private-label carton with hangtag at 200 pieces, certified GRA report and packed private-label carton with hangtag at 200 pieces.
What Fails First on sizing Guide
size-step drift
A run gauged at size 6 and estimated elsewhere ships a size 8 that measures 7.75. The mismatch shows up as a resize queue two weeks after launch, priced at USD 45-252 for the 200-piece Private Label Carton run.
In a 200-piece run this typically shows on 8 of pieces. Catching it means measuring stone retention after a 40-cycle wear test at the tray level, not inspecting the finished carton, shipped as private-label carton with hangtag and certified GRA report.
prong geometry
A prong that grips the girdle instead of the pavilion survives the showroom and fails the third ultrasonic clean. The seat has to be cut to the pavilion angle before the prongs close, the figure being USD 45-252 for a 200-piece run.
The commercial effect is a return shipment plus a resize labor claim, typically USD 9-14 per piece. Buyers who have seen it once put it in the purchase order; buyers who have not usually discover it on the first return, quoted at USD 45-252 per piece in private-label carton with hangtag.
rhodium burn-off
A 0.05 micron rhodium layer reads white in the tray and shows yellow at the shank in six months of daily wear. Thickness, not bath chemistry, is the variable that matters, which the Private Label Carton file records at USD 45-252 in private-label carton with hangtag.
Our countermeasure is a gauge and a written limit. It adds about 22 seconds per piece and removes the defect from the run rather than from the carton, and at USD 45-252 for 200 pieces that is the number the buyer signs.
MOQ, Samples and the Balance
The commercial frame is short enough to state in full. Minimum order is 50 pieces per design, and mixed designs travel in one shipment, so a 200-piece Private Label Carton order can carry three or four models without a separate setup charge. Sample pieces leave in 3-5 days when the components are in stock, and a new model adds about twenty days before the first article exists, and 200 pieces leaves Wuzhou in private-label carton with hangtag at USD 45-252.
Payment is 30 percent with the order and 70 percent against the bill of lading, with the balance window stated on the invoice rather than agreed by message. Prices quoted at USD 45-252 are FOB Guangzhou or Shenzhen; DDP is quoted separately because the duty line moves with the tariff schedule and not with our cost.
Packing follows the private-label carton with hangtag format at 200 pieces to the carton, and the packing list carries SKU, size and stone size so receiving can count without opening every box. Private-label cartons add three days for the print run and must be approved before the first bulk order, not after it, the figure being USD 45-252 for a 200-piece run.
Certification is GRA report for the lots that carry it, with a batch report and per-piece measurement of stone retention after a 40-cycle wear test for the lots below the threshold. The document set travels with the shipping papers, which is what a customs broker asks for at the port rather than after clearance, and at USD 45-252 for 200 pieces that is the number the buyer signs.
A rejected tray is settled inside the same order cycle against the retained reference piece. If the difference sits on our retained sample we replace or credit; if it appeared in transit we split the assay cost and file with the carrier, and that rule is written on the order before the deposit clears, with GRA report and private-label carton with hangtag stated on the same sheet.
AQL, Tray Checks and What a QC Report Should Say
This is the question that separates a trading company from a factory, and on sizing Guide the answer is usually shorter than buyers expect, quoted at USD 45-252 per piece in private-label carton with hangtag.
The commercial version of this question for sizing Guide is simple: what does a failure cost the buyer, and who pays it. In our terms the answer is a replacement inside the same order cycle, with the retained reference tray as the arbiter, and 200 pieces leaves Wuzhou in private-label carton with hangtag at USD 45-252.
That clause matters more than a discount on sizing Guide. A 4% lower unit price disappears on the first rejected tray; a written responsibility clause does not, shipped as private-label carton with hangtag and certified GRA report.
Carton Cube, Duty and the Freight Line That Surprises Buyers
Buyers ask it in the first call about sizing Guide and rarely get a number they can put in a spreadsheet, priced at USD 45-252 for the 200-piece Private Label Carton run.
We run this check per tray rather than per carton because the defect that matters on sizing Guide is the one that repeats. A single odd piece is noise; a pattern across one tray is a process problem and it will be in every tray made after it, and at USD 45-252 for 200 pieces that is the number the buyer signs.
The report the buyer receives states the count per tray, the measured average and the outlier count for sizing Guide. It is deliberately unglamorous, and it is the document that settles most disputes before they start, the figure being USD 45-252 for a 200-piece run.
From Spec to private-label carton with hangtag
Our process is deliberately boring, because boring is what survives a bulk run with several sets of hands on it, the figure being USD 45-252 for a 200-piece run.
- Agree the stamp position, the hangtag copy and the box print before the first carton.
- Print the cartons and hangtags in one run: a sticker on a matte box reads as a repack.
- Set the barcode and the FNSKU mapping for every SKU before the label file is approved.
- Build the first carton at the quoted quantity so the pack-out is proven, not assumed.
- Hold a retained carton as the pack reference for every reorder.
A first order at 50 pieces per design is a measurement rather than a purchase. It tells you what stone retention after a 40-cycle wear test and prong tip height within +/-0.10 mm looks like from this line, shipped as private-label carton with hangtag and certified GRA report, which the Private Label Carton file records at USD 45-252 in private-label carton with hangtag.
A 200-Piece Test Run
The first order should be small enough to inspect completely and large enough to keep the gauge check independent of the shift, with GRA report and private-label carton with hangtag stated on the same sheet, the figure being USD 45-252 for a 200-piece run.
Put the reject rule in writing before the deposit. The Private Label Carton conversation after arrival is shorter when the rule is on the order already, on a 200-piece Private Label Carton order at USD 45-252.
The Dock Check on sizing Guide
We ship from Guangzhou or Shenzhen, and the port choice follows the carrier rate rather than a fixed habit, and at USD 45-252 for 200 pieces that is the number the buyer signs.
DDP suits a first Private Label Carton order because the duty invoice arrives after the carton clears, and that is the line buyers forget to budget, certified GRA report and packed private-label carton with hangtag at 200 pieces.
The arrival check is three steps and none needs a lab: count against the packing list, weigh a sample, measure ten pieces, on a 200-piece Private Label Carton order at USD 45-252.
Frequently Asked Questions
What is the minimum order for sizing Guide?
50 pieces per sizing Guide. Designs mix inside one shipment, so a first order of three designs at 50 pieces each is normal for a new US account. Below 50 the gauge check stops being independent of the shift, shipped as private-label carton with hangtag and certified GRA report.
Do you supply certificates for sizing Guide?
GRA report on sizing Guide above the threshold stated on the quote. Below it we supply a batch report plus per-piece measurement of stone retention after a 40-cycle wear test, which is what a counter or a listing actually needs, on a 200-piece Private Label Carton order at USD 45-252.
How do you handle a rejected tray?
We replace or credit inside the same order cycle. The retained reference tray decides: if prong geometry shows on our retained piece we own it, and if it appeared in transit we split the assay cost and file with the carrier, and the Private Label Carton quote for it sits at USD 45-252.
What are the payment terms?
30 percent deposit with the order, 70 percent against the bill of lading. For accounts on a second order we quote 30/70 with a 15-day balance window once the first shipment has cleared, and the Private Label Carton quote for it sits at USD 45-252.
What is the minimum order for sizing Guide?
50 pieces per sizing Guide. Designs mix inside one shipment, so a first order of three designs at 50 pieces each is normal for a new US account. Below 50 the gauge check stops being independent of the shift, shipped as private-label carton with hangtag and certified GRA report.
Next Step
Send a photo or a drawing of the piece you want in private-label carton with hangtag, and the reply carries a price, a calendar and the four measurements, which is USD 45-252 on the Private Label Carton schedule.
The factory behind sizing Guide here is Wuzhou HengliLai Jewelry Co., Ltd., operating since 2009 in Wuzhou, Guangxi, at roughly 60,000 pieces a month. Reach the export desk at service@holycome.com or +86 18078079070 on WhatsApp, on a 200-piece Private Label Carton order at USD 45-252.
Related reading: Sizing Guide Vermeil Upgrade: Sample to Container: The Real Calendar - HOLYCOME Industry Insights Valentine Program: The Reject Tray Policy That Decides a Partnershi - HOLYCOME
